Tech-source Raptor DL-Lite Drivers for Linux Manual de usuario descargar pdf (Pagina 14)

Raptor DL-Lite Drivers for Linux Installation & Reference Manual

3-4

NOTE: You must install the MOX package if you plan on running

the cards in MOX mode. The MOX package is common to all

Raptor cards.

3.4 New Device

One new device name is created in the /dev directory for each

Raptor card. It is denoted by rapdlt#, where # represents an

instance number assigned by the operating system. For

example, /dev/rapdlt0 is the first Raptor card seen by the

system. /dev/rapdlt1 will be the second card seen by the

system and so on.

3.5 Changing Resolution

The resolution of the Raptor DL-Lite is fixed at 2560x1600 for the

Apple LCD monitor.

3.6 Configuring XFree86 Server for PC

Graphics Hardware

This section assumes that the XF86Config file was configured

to work properly with your existing VGA/SVGA cards. For

documentation on how to install and configure your VGA/SVGA

card, please refer to the XFree86 documentation.

After installing the Raptor drivers, three sections will be added to

the /etc/X11/XF86Config-4 file for each type of card,

provided that the file exists in the system. Otherwise,

/etc/X11/XF86Config will be used. If you are using another

config file, the three sections can be imported from:

/etc/X11/XF86Config.rapdlt

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Sin comentarios

Tech-source Raptor DL-Lite Drivers for Linux Manual de usuario Pagina 14