Tech-source Raptor DL-Lite Drivers for Linux Manual de usuario descargar pdf (Pagina 16)

Raptor DL-Lite Drivers for Linux Installation & Reference Manual

3-6

3.6.1 Monitor Section

This section for Raptor cards should remain unchanged.

3.6.2 Device Section

Identifier: Each Raptor card instance should have a

unique identifier. This identifer is used in the

Screen section.

NOTE: The BusID value in the configuration file must be

changed manually. Please see the description below for details.

BusID: Depending on the machine and the slot the

card is in, it might receive a unique BusID.

When the driver attaches, it will print out the

device name and BusID. To check the

BusID, type dmesg|grep rap. The

output should look similar to the following:

TSI: rapdlt0 (BusID 0:9:0) is

Raptor DL-LITE @ 2560x1600

In the example above, the Raptor DL-Lite

has a BusID of PCI:0:9:0. Change the

BusIDs of the cards in the XF86Config file

to match the BusIDs reported by the

drivers.

Option "Device": This field specifies the device name of the

Raptor card. The first Raptor card seen by

the system will be /dev/rapdlt0 and the

second will be /dev/rapdlt1 and so on.

The device name and the BusID specified

earlier in this section must correspond to the

same card.

Option "Mode": This field specifies pixel modes. It can be

one of the following.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Sin comentarios

Tech-source Raptor DL-Lite Drivers for Linux Manual de usuario Pagina 16