Tech-source Raptor Drivers for Linux Manual de usuario descargar pdf (Pagina 29)

Chapter 4 – Software Installation for T-Class Cards

4-7

BusID: Depending on the machine and the slot the

card is in, it might receive a unique BusID.

When the driver attaches, it will print out the

device name and BusID. To check the

BusID, type dmesg|grep rap. The

output should look similar to the following:

TSI: rap2kt0 (BusID 0:9:0) is

rap2kt @ 2048x2048

In the example above, the Raptor 2100T

has a BusID of PCI:0:9:0. Change the

BusIDs of the cards in XF86Config to

match the BusIDs reported by the drivers.

Option "Device": This field specifies the device name of the

Raptor card. The first Raptor card seen by

the system will be /dev/rap2kt0 and the

second will be /dev/rap2kt1 and so on.

The device name and the BusID specified

earlier in this section must correspond to the

same card.

Option "Mode": This field specifies pixel modes. It can be

one of the following.

8 8-bit PsuedoColor

8+24 Simultaneous 8-bit PsuedoColor and 24-bit

True Color

24 24-bit True Color

8+8 Two 8-bit PseudoColor visuals

mox16 MOX, 8-bit Normal, 13-bit Group, 5-bit

Absolute

mox24 MOX, 8-bit Normal, 21-bit Group, 13-bit

Absolute

mox32 MOX, 8-bit Normal, 24-bit Group, 21-bit

Absolute

mox16radar MOX16 with radar scan converter input

mox24radar MOX24 with radar scan converter input

8radar 8-bit PsuedoColor with radar scan converter

input

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 63 64

Sin comentarios

Tech-source Raptor Drivers for Linux Manual de usuario Pagina 29