Tech-source Raptor Drivers for Linux Manual de usuario descargar pdf (Pagina 43)

Chapter 5 – Invoking The X Server

5-11

5.7.2 Setting Resolution and Refresh Rate

To select both a specific resolution and a specific refresh rate,

both the Monitor and the Screen sections of the config file

need to be modified. A list of supported resolutions along with

their corresponding timing numbers is available in the file

/etc/X11/tsi_modeline. Extract the desired entry from

/etc/X11/tsi_modeline and insert it into the Monitor

section as shown.

Section "Monitor"

Identifier "CustomMonitor"

VendorName "Unknown"

ModelName "Unknown"

HorizSync 31 - 90

VertRefresh 55 – 120

ModeLine "VESA1152x900x85" 121 1152 1216 1344 1568 900

901 904 947 +HSYNC +VSYNC

In addition, the option “Modes” in the Screen section should be

changed to match the name of the resolution in the ModeLine

field of the Monitor section as shown below. Please ensure

that in the Monitor section, the HorzSync and VertRefresh

fields are set to values that are supported by the monitor and

correspond to the desired resolution. In this example the

resolution is set to VESA1152x900x85 in 8-bit mode.

Section "Screen"

Identifier "Raptor1100T"

Device "Raptor1.1KT"

Monitor "CustomMonitor"

DefaultDepth 8

SubSection "Display"

Depth 8

Modes "VESA1152x900x85"

EndSubSection

SubSection "Display"

Depth 16

Modes "1280x1024"

EndSubSection

SubSection "Display"

Depth 24

Modes "1280x1024"

EndSubSection

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 63 64

Sin comentarios

Tech-source Raptor Drivers for Linux Manual de usuario Pagina 43